Installation Manual

MOR-HEAT-TRACE 1548-40R6P Power Connection Kit with 2 End Seals - Mor Electric Heating Associates, Inc.

End Seal

This kit includes enough tubing to make 2 end seals.

TOOLS REQUIRED:

Diagonal cutters, needle-nose pliers,

utility knife; heat gun or propane

torch.

a. Score and remove 3” of the outer jacket

from the end of the heater.

b. Slide the braid back from the end of the heater

and cut about 1 1/2” squarely off the end of the

heater, making sure the conductors are not in

contact with each other.

c. Slide a 1/2” x 1 1/2” long piece of shrink sleeve

over the end of the heater allowing 1” to cover the

heater and 1/2” to extend beyond the end of the

heater.

1419-35R6P Rev. 01

d. Apply heat to shrink the sleeve around the

heater. While the sleeve is still hot, squeeze the

open end of the sleeve with the needle nose pliers

and hold together until cool to seal the shrink sleeve

end. If end does not remain visibly sealed when

pliers are removed, repeat this sealing step. The

end must remain visibly sealed when the pliers are

removed.

e. Slide the braid over sealing shrink sleeve and

twist end of braid into a pigtail.

f. Slide the 3/4” x 4” long piece of shrink sleeve

over the braid so that 3/8” extends out past the end

of the pigtail.