Installation Manual

MOR-HEAT-TRACE 1548-40R6P Power Connection Kit with 2 End Seals - Mor Electric Heating Associates, Inc.
2
1
2
3
5
7
4
6
8
Outer jacket
Braid
Inner jacket
Conductive core
Buss wires
(16 AWG)
Slide compression
ring, grommet ring, and
grommet onto heating
cable.
6 1/2”
Do not cut through
braid or inner jacket
Strip outer jacket as
shown.
Work opening through
ground braid at jacket,
bend back, and pull out
inner core. Twist braid into
a pigtail.
Leave 1/2” inner
jacket covering core.
Strip inner jacket as
shown.
1/2”
6”
1/2”
Cut inner core at end
as shown. Roll back
with pliers and
separate the bus wires
from the core.
Remove core material
from bus wires.
Retwist bus wires.
Heat-shrink the tubes
into position, keeping the
heat source moving from
side to side.
Install the 1/8” x 5 1/2” heat-shrink
tubes over bus wires.