Installation and Operation Manual

8WirelessSNRInstallationandOperationManual
059049-00 Rev. ' HeatͲTimerCorp.
DetailedOperation
ControlTheory
TheHeatͲTimerWirelessNetworkSensorSystemisdesignedtobeusedinavarietyof largebuildings,gardenapartments,andin
retrofitapplications.Thisgivesboththeaccuracyandflexibilityrequiredtomonitorthosebuildings'temperatures(givingthecontrol
morepowertosavefuelwhilekeepingspacetemperaturesatcomfortable
levels).Thesystemeasestheinstallationofspacesensors
inbuildingswereitwouldbedifficultorcostprohibitiveutilizingother means,andgivesHeatͲTimerPlatinumcontrolsaccesstothe
wirelesssensordata,whichitlogsandusesformonitoringandfineͲtuningitsoperation.
Theprimaryintegralcomponentsof
thesystemare:theMSIHub,Transceivers(TRV),WirelessSensors(SNR),andWireless
Temp erat ureModules(WTM).TheSNRscommunicatetheirinformationtoanearbyTRVordirectlytoanMSIHub.Datareceivedbya
TRVistransmittedeithertoanotherTRVortotheMSIHub.Alldatareceived
bytheMSIHubiscommunicatedtothePlatinumcontrol.
Troubleshooting
Symptom PossibleCause RecommendedAction
BothredstatusLEDs(orallthreeLEDs)are
continuouslyblinking.
SystemIDhasnotbeenconfigured. ConfiguretheSystemID.IftheLEDsare
stillblinkingaftertheSystemIDhasbeen
configured,contactCustomerSupport.
StatusLEDs arenotblinkingafterthe
batteriesareinstalled.
Batteriesnotinstalledcorrectly,orare
weakordrained.
Verifythebatteriesaregoodandare
installedcorrectly(check thepolarity
diagramonthebase).
SystemIDisalreadyconfigured. Ifthe SystemIDhasbeenpreviously
configuredandisknown,noactionis
required.
IftheSystemIDisnotknown,reconfigure
theSystemID.
Dataisnotbeing
transmittedorreceived
bytheWirelessSNR.
Batteriesweakordrained. ReplacebothAAalkalinebatteries
(HeatͲTimerp/n020008Ͳ00).