Installation and Operation Manual

InstallationInstructions7

059049-00 Rev. 'HeatͲTimerCorp.

•ProgramtheSystemIDusingtheHandͲHeldWirelessProgrammer

a. SetthedesiredSystemIDintheHandͲHeldWirelessProgrammer.RefertotheHandͲHeldWirelessProgrammermanual

forinstructions.

b. AftertheSystemIDisset,pressthe[Mode]button toreturntothemainmenu,selectConfigDevices,andthen

press

[Enter/Żൣ].

c. SelectSystemID,andthenpress[Enter/Żൣ].TheSystemIDcurrentlyprogrammedintotheWirelessProgrammeris

displayed.

d. InsertthebatteriesintotheWirelessSNRandthenconnectthephonecablefromtheWirelessProgrammertothe

sensorbeingprogrammed.PressFto

loadtheSystemID intotheWirelessSNR.

e. WhenACKisdisplayedontheWirelessProgrammerscreen,thisisconfirmationthattheWirelessSNRhasaccept edthe

SystemID.Verifythatthesensor’sredandgreenstatusLEDshavestoppedblinking.

f. DisconnecttheWirelessSNRfromtheWirelessProgrammer,andthencontinue

with“MountingtheWirelessSNR”on

page 7.

MountingtheWirelessSNR

NOTE:TheSystemIDmustbeprogrammedpriortomountingtheWirelessSNR.Ensurethestepsprovidedin“Programmingthe

SystemID”onpage 5havebeencompletedbeforecontinuing.TheWirelessSNRcovershouldalreadyberemovedandthebatteries

installed.

1. Selectanappropriate locationtomounttheWirelessSNR.The

locationmustmeetthefollowingminimumrequirements:

•Thelocationshouldbeonawallthatwillrepresentthecurrentlivingspacetemperature(forexample:inthelivingroom,

5feet(1.5meters)highonaninteriorwall).

•Themountingsurfaceshouldbeflatandstrongenoughtoholdtheweightofthedevice.

•DO

NOTmountthedeviceinalocationwhereitwillbeexposedtoheating,cooling,orhumiditysources(suchasnear

radiators,heating/coolingvents,windows,doors,orinakitchenorbathroom.

2. Markthemountinglocationthroughthetwomountingholes(1)intheWirelessSNRbase,andthensecurethe

WirelessSNRin

placeusingthesuppliedscrewsandwallanchors.

3. SnapthecoverbackontotheWirelessSNR.

4. Continueto“PerformingtheICMSConfiguration”onpage 7whenalldeviceshavebeenmounted.

PerformingtheICMSConfiguration

AftertheWirelessSNRhasbeenconfiguredandinstalled,itmustbeconfiguredinICMS.

1. WritethelocationoftheWirelessSNRontheIDcardprovidedwiththedevice(forexample,Apt.5A).

2. Accesswww.HTControls.comandlogin.

3. ConfigureICMSwiththeapplicableWirelessSNRinstallationdata(deviceID,name,type,

andlocation).

4. AftertheICMSconfigurationiscomplete,logoutofICMS.