Installation and Operation Manual

6WirelessSNRInstallationandOperationManual
059049-00 Rev. ' HeatͲTimerCorp.
3. RemovethebatteriesfromtheWirelessSNR,andthenprogramtheWirelessSNRSystemIDusingoneofthefollowingthree
methods:
•ProgramtheSystemIDWirelesslyusingaTransceiverorMSIHub
NOTE:Transceiversoftwaremustbeversion13orabove.
a. EnsuretheTransceiverorMSIHubhasbeenpoweredͲonand
hasalreadybeenprogrammedwiththeSystemID.Observe
theMSIHubstatusLEDs(1).IfthestatusLEDsarenotblinking,orareblinkingonlyonceevery15seconds,aSystemID
hasbeenprogrammed.IftheLEDsareblinkingrapidly(oncepersecond),aSystemIDhasnotbeen
programmed.
b. PressandholdtheSystemIDSet/ResetbuttonontheMSIHub(2)orTransceiverfor5secondsoruntiltheredLEDstarts
blinking.
NOTE:TheSystemIDSet/ResetbuttonislocatedontheboardfortheTransceiver.
c. InsertthebatteriesintotheWirelessSNRandobservethesensor’sredand
greenstatusLEDs .WhentheLEDsstop
blinking,thesensorisprogrammedandreadytobemounted.
d. AftertheSystemID hasbeenprogrammed,presstheSystemIDSet/ResetbuttonontheMSIHuborTransceivertoreturn
thedevicetonormaloperation.
e. Continuewith “MountingtheWirelessSNR”onpage 7.
•Programthe
SystemIDby ConnectingWirelessSNRtotheMSIHub
a. EnsuretheMSIHubhasbeenpoweredͲonandhasalreadybeenprogrammedwiththeSystemID.ObservetheMSIHub
statusLEDs(1).IfthestatusLEDsarenotblinking,orareblinkingonlyonceevery15seconds,aSystem
IDhasbeen
programmed.IftheLEDsareblinkingrapidly(oncepersecond),aSystemIDhasnotbeenprogrammed.
b. ConnecttheprovidedblackMSIRJ11communicationscable(2)totheprogrammingconnectionontheMSIHub(3)and
WirelessSNR(4).
c. InsertthebatteriesintotheWirelessSNRandobservethesensor’s
redandgreenstatusLEDs(5).WhentheLEDsstop
blinking,thesensorisprogrammedandreadytoinstall.
d. DisconnecttheWirelessSNRfromtheMSIHub,andthencon tinuewith“MountingtheWirelessSNR”onpage 7.
CAUTION
TheblackMSIRJ11communicationscable(provided)MUSTbeusedwhenconnectingtheMSIHub
totheWirelessSNR.UsinganyothercablemayresultindamagetotheMSIHuband/orthe
WirelessSensor/Transceiver.
1
2
MSIHub
1
3
MSIHub
WirelessSNR
4
2
5