Installation and Operation Manual

InstallationInstructions5

059049-00 Rev. 'HeatͲTimerCorp.

InstallationInstructions

TheWirelessSNRinstallationprocessconsistsofthefollowingbasicsteps:

1. ProgrammingtheWirelessSNRSystemID.

2. Selectingappropriatelocationsandmountingthedevice(s).

3. PerformingfinalICMSconfiguration.

RequiredMaterials(NotSupplied)

Thefollowingmaterials/toolsarerequiredforinstallation,butarenotsupplied:

• Generaltoolkit(screwdrivers,powerdrill,etc.)

ProgrammingtheSystemID

FortheSNRstofunctioninawirelesssystem,eachmustcommunicatewithanearbyTransceiver(TRV)orMSIHub.Eachwireless

networkshouldhaveauniqueSystemIDthatenablesallwirelesscomponentswiththatIDtocommunicatewitheachother.

1. OpentheWirelessSNRbygentlypressingonthe

baselockingtab(1)andremovingthecover,andtheninserttwoAAalkaline

1.5Vbatteries(2)(HeatͲTimerp/n020008Ͳ00).

NOTE:Besuretoinstallthebatteriesintheproperdirection.

2. ObservetheWirelessSNRstatusindicators(3).IftheLEDsareblinkingeverysecondafterinstallingthebatteries,the

SystemID

isnotset(bydefault,thefactorysettingisthattheSystemIDisnotset).

NOTE:IftheLEDsarenotblinking,verifythebatteriesaregoodandareinstalledcorrectly.Ifthebatteriesaregoodandthe

LEDsarenotblinking,theSystemIDhasalreadybeenset.

IftheSystemIDisknown,continuewith“MountingtheWireless

SNR”onpage 7.IftheSystemIDisnotknown,theSystemIDmustbeclearedusingthefollowingsteps:

a. RemovethebatteriesfromtheWirelessSNR.

b. PressandholdtheModebutton (4)whilereͲinstallingthebatteries.Continueholding

theModebuttonuntiltheWireless

SNRstatusindicators(3)startblinkingoncepersecond.

c. ContinuewithStep 3.