Instructions

10
Retro-Line | Product Code
Retro-Line | Accessories
Product Code Description
HLA-120 120V plug-in thermostat (GFC)
GFA-STAT 120/240V hard wire thermostat with GFEP (CS)
TIMER-120P 120V plug-in timer (GFC)
TIMER-240P 240V plug-in timer (GFC)
TIMER-CS 120/240V hard wire timer (CS)
MA-10 120/240V GFCI/ELCI (CS)
INSUL-1.00 Insulation sleeve for 1 inch ID pipe (1 5/8 inch ID, 6 ft long)
INSUL-1.25 Insulation sleeve for 1 1/4 inch ID pipe (1 7/8 inch ID, 6 ft long)
INSUL-2.00 Insulation sleeve for 2 inch ID pipe (2 5/8 inch ID, 6 ft long)
HLP-TAPE Tape for insulation sleeve butt joints (100 ft)
WARRANTY Extended 10 year limited warranty
NOTE: The heating
cable is measured
and cut to the length
of system ordered.
Some of this length
will remain within
the interface fitting.
Example: RL – 125 – 100 – CTS – GFC
Cord-Set Type
GFC Ground fault protected
5-15P 120V / 6-15P 240V
CS Cord connected (No GFCI
)
Fitting Type
ID Internal pipe diameter ID-IPS tee fitting
CTS Copper tubing size CTS tee fitting
OD Outside pipe diameter OD-IPS tee fitting
IP Male Adapter (thread size) MIPT fitting
NI 1" and 1.25" kit internal pipe diameter ID tee
Length of Heater
6 – 230 feet 3 watt /120V systems
6 – 550 feet 3 watt /240V systems
Produc
t
RL 120 volt Retro-Line
RL2 240 volt Retro-Line
Fitting/Pipe Size
075 Fitting/Pipe Size 3/4" *
100 Fitting/Pipe Size 1"
125 Fitting/Pipe Size 1 1/4"
**
150 Fitting/Pipe Size 1 1/2"
200 Fitting/Pipe Size 2"
***
*
Not available in IP
** NI fitting type must chose 125
*** Not available in CTS
Retro-Line | Sample Installation