Quick Start Manual

DVC/DVH Inverter Mini-Split Heat Controller

Number Name of Accessories Qty/unit

1 Wall Bracket 1

2 Plastic Dry Wall Anchor 5-8 depending on model

3 Self-tapping Screw A ST 3.9X25 5-8 depending on model

4 Seal (heat pump models only) 1 (Part 202720090001)

5 Drain Elbow (heat pump models only) 1 (Part 20110120011s)

6 Remote Controller (with 2 AAA batteries) 1

7 Self-tapping Screw B ST2.9X10 2

8 Remote controller holder

9 Nano silver air lter (eld installed, not shown) 2

Note: Except for the parts provided above, all other parts needed for installation must be purchased

Accessories

• This illustration is for explanation purposes only.

• Copper lines must be insulated independently.

Drain Elbow

Seal

“U” bend (cable)

Fig. 8

Tools needed for installation:

Level gauge

Screwdriver

Electric drill, Hole core drill o 2.5”(65mm)

Flaring tool set

Adjustable wrench

Refrigerant leak detector or a bottle of soap water

Vacuum pump

Gauge manifold

Thermometer

Multimeter

Pipe cutter

Tape Measure

Cable to wire units

Refrigerant line set for R-410A

Micron gauge

Allen wrench set (metric)

Additional drain pipe

Insulation

Air Filter

Remote Controller

holder

Remote Controller

Mounting screw

ST2.9x10-C-H