8'x10 Granbury Instructions

ROOF PANELS

2" (5,1 cm)

PARTS REQUIRED:

3/4"

GAUGE BLOCK

GAA

Two Nails

96"

(121,9 cm)

3/4"

(1,9 cm)

Gauge

Block

Fig. B

Flush at peak

Fig. A

Flush at peak

Fig. C

1/2"

(1,3 cm)

Gauge

Block

Fig. D

7/16 x 48 x 96"

(1,1 x 121,9 x 243,8 cm)

Move to the opposite end. Using the edge of the panel as a lever, move the

panel side-to-side until the top corner is ush to the peak (Fig. C) and there

is a 1/2" measurement to the gable trim (Fig. D).

If necessary, move the rafter to obtain the 1/2" measurement.

Secure panel using (2) 2" nails in the corners.

You must square the roof by attaching (1) panel rst. You will use the panels’ long edge as a lever to bring your roof

into square. Commonly known as “racking”.

Roof panels may cause serious injury until securely fastened.

Place a 47-7/8 x 48" with a 3/4" measurement on the rst

rafter from back wall (Fig A)

and the panel ush at the peak (Fig. B).

Secure panel using (2) 2" nails in the corners.

BEGIN

Note: all roof panels need to be installed with the rough side up (painted grid lines).