Installation Guide

x4
19/32 x 3 x 26-5/8" (1,5 x 7,6 x 67,6 cm)
AH
19/32 x 3 x 72" (1,5 x 7,6 x 183 cm)
x1
ZJ
58
Fig. C
(11) Special Coating Screws
3/4" (1,9 cm)
Screws from behind.
DOUBLE DOORS - GABLE WALL
PARTS REQUIRED:
3/4" (1,9 cm)
x66
CENTER
9"
(22,9 cm)
9"
(22,9 cm)
2" (5,1 cm) Finish Nails
x5
Two Screws
Door
Trim
Fig. A
Fig. B
Door
Panel
AH
GPL
GPR
ZJ
Nail into
framing.
CENTER CENTER
AH
9"
(22,9 cm)
9"
(22,9 cm)
Center metal threshold between doors and secure using eleven 3/4"
special coating screws into  oor as shown (Fig, C).
7
You have  nished securing your door and trim.
FINISH
8
2
Attach upper horizontal door rails AH with four 3/4" screws from behind to center of doors as shown.
4
Attach lower horizontal door rails AH with four 3/4" screws from behind to center of doors as shown.
BEGIN
1
Secure door trim from inside using 3/4" screws as shown (Fig. A).
6
Center trim ZJ over doors and secure using  ve 2"  nish nails into framing as shown.
5
Reinforce the door trim using 3/4" screws through door panel into trim (Fig. A).
Locate screws as shown (Fig. B). Use two screws at seams.
x1
64" Metal Threshold
3/4" (1,9 cm) x17
Bagged seperately / special coating
x5
2" (5,1 cm)
Attach GPL and GPR  ush to installed door trim AH with 3/4" screws from inside of doors (Fig. B).
3
x1
19/32 x 2-1/2 x 51" (1,5 x 6,3 x 129,5 cm)
GPR
GPR
x1
GPL
19/32 x 2-1/2 x 51" (1,5 x 6,3 x 129,5 cm)