Installation Guide

48
7/16 x 27-1/4 x 32-5/8"
(1,1 x 69,2 x 82,9 cm)
x4
7/16 x 27-1/4 x 48"
(1,1 x 69,2 x 121,9 cm)
x4
7/16 x 32-5/8 x 48"
(1,1 x 82,9 x 121,9 cm)
x4
ROOF PANELS
2" (5,1 cm)
PARTS REQUIRED:
x230
3/4" GAUGE
BLOCK
Roof panels may cause serious injury until securely fastened.
1
BEGIN
Attach the 27-1/4" x 32-5/8" panel with a 3/4" (1,9 cm) measurement on the rafter (Fig A)
and the panel ush at the gable end overhang (Fig. B).
Secure panel with two 2" (5,1 cm) nails in the corners.
2
Attach a 48"x 96" roof panel with a 3/4" (1,9 cm) measurement on
the 5th rafter (Fig A),ush to the installed panel and ush at the
gable end overhang (Fig. B).
Secure panel with two 2" (5,1 cm) nails in the corners.
Note: all roof panels need to be installed with the rough side up (painted grid lines).
7/16 x 48 x 96"
(1,1 x 121,9 x 243,8 cm)
x2
Flush
3/4"
(1,9 cm)
Gauge
Block
Fig. A
Flush
at rafter ends.
27-1/4" x 32-5/8"
Two Nails
Fig. B
Flush at edge.
Two Nails
Flush
at rafter ends.
Fig. B
Flush
3/4"
(1,9 cm)
Gauge
Block
Fig. A
48"x 96"