Installation Guide

13
PARTS REQUIRED:
x 118
2" (5,1 cm)
x 10
1-5/8" (4,1 cm)
RAFTER ASSEMBLY
x10
6 x 24" (15,2 x 61 cm)
OSB OR WOOD GRAIN
x10
2 x 4 x 75-1/4" (5,1 x 10,2 x 191,1 cm)
ECN
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
1/4" (1,9 cm)
GAP
ECN x2
ECN x2
Fig. A
Fig. B
Fig. C
Glue where
gusset installs
Keep rafters fi rmly against PVA at both ends when securing gusset.
You have  nished assembling your rafters.
Repeat steps 1 through 3 to assemble four more rafters.
Remove PVA's from  oor.
Flip rafters over and attach a second gusset using glue and (12) 2" nails. No need to use jig for this gusset.
4
5
3
2
Keep ECN  rm against outside PVA's as shown (Fig.A) and push rafters tight to the middle PVA. Rafters should
touch at tips (Fig. A).
Apply glue to rafters where gusset will attach (Fig. B).
Place gusset onto ECN holding a 1/4" gap from edge (Fig. C) and keeping rafters  rm as instructed. Secure
gusset using one 1-5/8" screw into each rafter. HINT: These screws will help hold the measurements when you
nail on gussets.
Use ten 2" nails to  nish securing the gusset to the rafters to pattern shown in Fig. C.
BEGIN
¸
1
Place two rafters ECN into the jig as shown.
FINISH
6
1-5/8" (4,1 cm)
Screw
120-3/4"
(306,7 cm)