Installation Guide
51
1-1/4" (3 cm)
Flush to top
of panel.
GABLE TRIM
PARTS REQUIRED:
2 x 3 x 58" (5 x 7,6 x 147,3 cm)
x4
CDD
Flush
CDD
CDD
x24
DOOR
FINISH
4
Position one CDD ξ ush to front panel edge and center on right edge of
groove (Fig. A). Attach trim with eight 1-1/4" screws from inside. Install
two screws at seam (Fig. B).
Position second CDD ξ ush to panel edge and ξ ush to CDD already attached (Fig. A).
Attach trim with eight 1-1/4" screws from inside. Install two screws at seam (Fig. B).
Repeat steps 1-2 to attach the back trim.
You have attached your upper trim. Continue to attaching your endcaps.
2
3
BEGIN
ΒΈ
1
Fig. A
Fig. B
8" (20,3 cm)
Approximately