Installation Guide

PARTS REQUIRED:

3" (7,6 cm)

DOORS

Flush

against wall panels.

Fig. A

2 x 3 x 69" (5 x 7,6 x 175,3 cm)

Center doors on right edge of groove as shown (Fig. B).

Check ledger board is still flush under panels.

Remove temporary supports and check doors open

properly.

Screw hinge boards into wall supports and floor using four 3" screws as shown.

Make sure screws go into framing and floor (Fig. C, D).

Attach temporary support OO as a ledger board flush under wall

panels for doors to rest on, using three 3" screws (Fig. A).

3" (7,6 cm)

Screws into the wall

support and floor frame.

Fig. B

Center 3/8"

measurement on

right edge of groove.

Fig. C

3/8"

(1 cm)

Fig. D

Angle 3" (7,6 cm)

Screw

FINISH

You have finished installing your doors.

GABLE 10' x 8' GABLE 10' x 12'