Installation Guide

51
48”
(122 cm)
ROOF PANELS 10' x 12'
3/4"
GAUGE BLOCK
GAA
Move to the opposite end. Using the long
edge of the panel as a lever move the panel
side-to-side until the top cor ner is
ush to
the peak (Fig. C) and there is a 1/8" (0,3 cm)
measurement to the gable tr im (Fig. D).
You may need to move your backwall to get
the 1/8" measurement. Secure panel with
two 2" nails in the cor ners.
2
You must square the roof by attaching one panel rst. You will use the panels’ long
edge as a lever to bring your roof into sq uare. Commonly known as “racking”.
Roof panels may cause serious injury
until securely fastened.
Attach the 48 x 96" panel with the rough side
up (painted-gr id lines side) with a 3/4" (1,9 cm)
measurement on the rafter (Fig A) and the panel
ush at the peak (Fig. B).
Secure panel with two 2" nails in
the corners.
1
BEGIN
Two Nails
Flush at peak.
Fig. B
1/8"
(0,3 cm)
Gable
Trim
Fig. D
Flush at peak.
Fig. C
2" (5 cm)
PARTS REQUIRED:
x 4
DOO
R
7/16 x 48 x 96"
(1,1 x 122 x 244 cm)
x2
3/4"
(1,9 cm)
Fig. A
GABLE 10' x 8'
GABLE 10' x 12'