Installation Guide
49
• FOR 10' x 12', SKIP TO PAGE 51.
GABLE 10' x 8'
GABLE 10' x 12'
Move to the opposite end. Using the long
edge of the panel as a lever move the panel
side-to-side until the top corner is flush to
the peak (Fig. C) and there is 1/8" (0,3 cm)
measurement to the gable trim (Fig. D).
You may need to move your backwall to get
the 1/8" measurement. Secure panel with two
2" nails in the corners.
2
You must square the roof by attaching one panel fist. You will use the panels’ long
edge as a lever to bring your roof into square. Commonly known as “racking”.
Roof panels may cause serious injury
until securely fastened.
Attach the 48 x 96" panel with the rough
side up (painted-grid lines side) with a 1/8"
measurement on the rafter (Fig A) and the
panel flush at the peak (Fig. B).
Secure panel with two 2" nails in
the corners.
1
BEGIN
Two Nails
48"
(122 cm)
1/8"
(3 mm)
Fig. A
Flush at peak.
Fig. B
1/8"
(3 mm)
Gable
Trim
Fig. D
Flush at peak.
Fig. C
DOOR
2" (5 cm)
PARTS REQUIRED:
x 4
7/16 x 48 x 96"
(1,1 x 122 x 244 cm)
x2
2//&0!.%,3fXf