Installation Guide

3
GABLE 10' x 8'
GABLE 10' x 12'
DRIP EDGE (Feet) .......................................
40 50
#15 ROOFING FELT (Sq ft. to cover) ......... 96 144
1" GALVANIZED ROOFING NAILS (lbs) ....
1/4 1/4
For roofing felt.
3-TAB SHINGLES (Bundles) ......................
4 5
PAINT FOR SIDING (Gallons).....................
1-1/2 2
Use 100% acrylic latex exterior paint.
(2) coats recommended.
1" GALVANIZED ROOFING NAILS (lbs.) ... 2 3
For shingles.
Xf
Xf
Xf
Xf
!,,3):%3
XfXf
#/-0,%4).'9/523(%$
You will need these additional materials:
!$$)4)/.!,-!4%2)!,3
2%&%24/4(%"!#+/&4()3-!.5!,!.$4(%-!.5&!#452%23).3425#4)/.3
&/2).34!,,!4)/./&3().',%3$2)0%$'%!.$&%,4
PAINT FOR TRIM .............................1 Quart
Use 100% acrylic latex exterior paint.
WOOD GLUE ....................... Exterior Rated
CAULK ..............................................2 Tubes
Use acrylic latex exterior caulk
that is paintable.
&/5.$!4)/./2&,//2-!4%2)!,3
• This shed kit includes a wood floor system. It does not include any floor panels.
• See below for the additional floor panel sizes and quantities required.
• This shed does not include any leveling materials.
• See the FLOOR LEVELING section on page 9 for recommended methods and suggested materials to properly level your
floor, as this will vary depending on your specific site.
&,//20!.%,3.OT)NCLUDED
You may need floor panels and nails to complete your floor. Floor panel sizes and quantities
are shown below.
Use a minimum of 3/4" (1,9 cm) Oriented Strand Board (OSB)
3/4 x 23-7/8 x 92-5/8" (1,9 x 60,6 x 235,3 cm)
3/4 x 23-7/8 x48" (1,9 x 60,6 x 122 cm) 3/4 x 23-7/8 x 48" (1,9 x 60,6 x 122 cm)
3/4 x 48 x 92-5/8" (1,9 x 122 x 235,3 cm)
3/4 x 48 x 92-5/8" (1,9 x 122 x 235,3 cm) 3/4 x 48 x 96" (1,9 x 122 x 243,8 cm)
x1
x1 x1
x2
x2 x1
/04)/.!,-!4%2)!,3