Installation Guide

42
GABLE 10' x 8' GABLE 10' x 12'
NOTE: 10' x 8' Gable Shown
2
3
Be sure the measurement between the panel
edge and the trim is the same along the entire
length. Then secure with one 2" nail in the upper
corner (Fig. D).
Nail along the panel edge into the trim using 2"
nails spaced 6" apart.
Secure the frontwall frame using two 3" screws
(Fig. E).
Screw through the frontwall trim into the top
plate (Fig. F), and angleds to hit floor frame at
bottom (Fig. G) using 3" screws.
Repeat process to secure the right side of
the frontwall.
Center frontwall on floor side-to-side.
The sidewall soffit will overlap the
frontwall 3/8" (Fig. A).
Nail the frontwall flush to the floor using
2" nails 6" apart. Angle nails to hit floor
frame (Fig. B).
Nail the lower sidewall corner to the
frontwall trim with one 2" nail (Fig. C).
1
BEGIN
Stand frontwall on floor.
It is important to secure the frontwall in the following order.
6"
(15 cm)
2" (5 cm)
Nail
6"
(15 cm)
Same
Measurement
Side
Panel
Fig. D
Trim
2" (5 cm)
Nail
Fig. E
3" (7,6 cm)
Screw
3" (7,6 cm)
Screw
Fig. F
2 x 3"
CENTER
6"
(15 cm)
6"
(15 cm)
2" (5 cm)
Nail
Fig. C
Trim
2" (5 cm)
Nail
Fig. B
Fig. A
Trim
Panel
Soffit
Panel
3/8" (0,9 cm) OVERLAP
Fig. G
3" (7,6 cm)
Screw
3" (7,6 cm)
Screw
2" (5 cm)
3" (7,6 cm)
&2/.47!,,).34!,,!4)/.
x8
x36
DOOR