Installation Guide

41
Xf
Xf
x4
x30
x8
x39
GABLE 10' x 8'
GABLE 10' x 12'
NOTE: 10' x 8' Gable Shown
6"
(15 cm)
6"
(15 cm)
CENTER
2" (5 cm)
Nail
Fig. A
Trim
Fig. D
Fig. F
3" (7,6 cm)
Screw
3" (7,6 cm)
Nail
Panel
Same
Measurement
Fig. C
Trim
2" (5 cm)
Nail
DOOR
3" (7,6 cm)
Screw
3/8" (0,9 cm)
OVERLAP
Fig. B
Trim
Panel
Soffit
Panel
Fig. E
3" (7,6 cm)
Screw
2x3"
Center sidewall on floor front to
back.
Nail the top of the sidewall so
the soffit panel overlaps the
backwall panel 3/8" (Fig. A).
Nail the lower sidewall corner to
the backwall trim with one
2" nail (Fig. B).
3
Nail down the bottom plate using two 3" nails
between the wall studs.
Screw through the backwall trim into the top and
plate (Fig. E), and angled to hit floor frame at
bottom (Fig. F) using 3" screws.
Repeat process to secure the left sidewall.
1
2
BEGIN
2" (5 cm)
3" (7,6 cm)
3" (7,6 cm)
3)$%7!,,3).34!,,!4)/.
Be sure the measurement between the
panel edge and the trim is the same
along the entire length. Then secure
with one 2" nail in the upper corner
(Fig. C).
Nail along the panel edge into the trim
using 2" nails spaced 6" apart.
Nail along bottom of panel using 2"
nails 6" apart. Angle nail to hit floor
frame (Fig. D).
Stand right sidewall on floor.
It is important to secure the sidewall in the following order:
Additional fasteners needed for 10' x 12' kit or kit. Same instructions apply.
DOO
R
DO
OR
x2