Installation Guide
34
48"
(122 cm)
3/4"
(19 mm)
3/4"
(19 mm)
GABLE 10' x 8' GABLE 10' x 12'
3/4" Gauge Block
Fig. A
Fig. B
3/4"
(19 mm)
3/4"
(19 mm)
2 Nails
2 Nails
Place the 48 x 72" panel onto wall frame with primed side up as shown. Note the lip and
square edges.
Use the gauge block to mark the 3/4" measurement on the wall stud. Locate the panel
flush under the soffit panel. Secure panel with two 2" nails in the corners (Fig. A).
7
6
5
Nail the panel using 2" nails 6" apart on edges
and 12" apart inside panel.
Ensure your wall frame is square by installing one panel and squaring frame.
Move to the opposite end. Using the long edge of the panel as a lever move the panel side-to-side
until you have a 3/4" measurement on the wall stud. Secure corner with two 2" nails.
LIP
EDGE
SQUARE
EDGE
Flush
Flush
Do not nail
in groove.
There will be an
overhang at top.
Primed Side
UP
2" (5 cm)
PARTS REQUIRED:
3/8 x 48 x 72"
(1 x 122 x 183 cm)
x2
x58
3/4"
GAUGE BLOCK
fXf3)$%7!,,0!.%,3
BEGIN HERE
6" (15 cm)
12" (30 cm)
For squareness maintain 3/4" and
flush under soffit panel.
DOOR