Installation Guide

21
125"
(317,5 cm)
1/4" (6 mm)
Gap
Gusset
Glue
GABLE 10' x 8'
GABLE 10' x 12'
BEGIN
¸
1
NOTE: 10' x 8' Gable Shown
NH as
temporary
supports
OO as
temporary
support
Rafter jig on wood floorRafter jig on concrete slab and sill plates
Contact at
peak.
x102
x10
RAFTERS
2" (5 cm)
FINISH
6
Apply glue on gusset and place on rafters.
Nail gusset onto rafter using 2" nails, staggered, as shown.
Repeat steps 1-4 to build two more assemblies for 10' x 8' Gable, four more
assemblies for 10' x 12' Gable, or six more assemblies for 10' x 16' Gable.
Flip over rafter assembly and glue and nail gusset to back side.
Unscrew jig and save blocks. Set aside rafters and proceed to building your back
wall.
5
4
2
3
PARTS REQUIRED:
2 x 4 x 65-7/8" (5 x
10 x 167 cm)
6 x 24" (15 x 61 cm)
x72
x6
x6
x10
CV
Place two rafter halves CV on floor jig.
• FOR 10' x 12', ASSEMBLE (5) RAFTERS TOTAL.
• FOR 10' x 8', ASSEMBLE (3) RAFTERS TOTAL.
10x8' 10x12'
DOOR