Installation Guide

Runners are generally

12" (30,5 cm) from

ends of floor frame

and under seams.

• 3" Screw angled into 4x4.

• (2) at each point frame and

4x4 touch.

Fig. B

Fig. A

(30,5 cm)

12"

(30,5 cm)

12"

DOOR

Second,

secure at

ends with

one fastener.

First, secure

at ends with

one fastener.

184-7/8"

(469,5 cm)

184-7/8"

(469,5 cm)

LEVELING & SQUARING A 10 x 12' FLOOR FRAME

BEGIN

Use level and check the frame is level before applying floor panels.

Check for frame squareness by measuring diagonally across corners. If the measurements are the

same, the frame is square. The diagonal measurement will be approximately 184-7/8" (469,5 cm).

When the frame is level and square secure one side of frame to the 4x4 runners using one

fastener at ends of each runner. At the opposite end of the frame, secure the frame to 4x4

runners with one fastener at ends of each runner making sure the frame remains square (Fig. A).

Once the floor frame is level and square fasten the frame at each point the frame contacts the 4x4

runners (Fig. B). Go to page 17.

See page 9 for the preferred floor leveling method.

FINISH

LEVEL AND SQUARE FLOOR FRAME

Before attaching floor decking, it is important to level and square the floor frame.

A level and square floor frame is required to correctly construct your shed.

GABLE 10' x 8' GABLE 10' x 12'