Installation Guide

6
10x8' 10x12'
10x16'
ALL SIZES
COMPLETING YOUR SHED
You will need these additional materials
TO VALIDATE YOUR WARRANTY YOU MUST USE THE FOLLOWING:
ADDITIONAL MATERIALS
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER’S INSTRUCTIONS
FOR INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
3-TAB SHINGLES (Bundles)....................
PAINT FOR SIDING (Gallons)..................
Use 10 0% acrylic latex exter ior paint.
1" GALVANIZED ROOFING NAILS (lbs).
For shingles.
PAINT FOR TRIM .............................1 Quart
Use 10 0% acrylic latex exterior paint.
CAULK ............................................ 2 Tubes
Use acrylic latex exter ior caulk that is paintable.
FOUNDATION OR FLOOR MATERIALS
• Your shed kit does not include a wood oor frame or oor panel materials.
• See page 8 for the additional
oor panel sizes and quantities required.
• This shed does not include any leveling materials.
• See the FLOOR LEVELING section on page 10 for recommended methods and suggested materials to properly level your
oor, as this will vary depending on your speci c site.
NOTES
468
1-½ 2 2-½
2
3
4
(2) coats r ecommended.
10x8' 10x12'
10x16'
DRIP EDGE (Feet)....................................
#15 ROOFING FELT (Sq ft. to cover).....
1" GALVANIZED ROOFING NAILS(lbs).
40 50
60
96 144
192
For r ng felt.
Shown actual size
NAIL BOXES (Not included)
3" (7,6 cm)
2" (5,0 cm)
x2 BOXES
x4 BOXES