Installation Guide

ROOF PANELS

Move to the opposite end. Using the long

edge of the panel as a lever move the

panel side-to-side until the top corner is

ush to the peak (Fig. C) and there is 1/8"

measurement to the gable trim (Fig. D).

You may need to move your backwall to

get the 1/8" measurement. Secure panel

with two 2" nails in the corners.

You must square the roof by attaching one panel st. You will use the panels’ long

edge as a lever to bring your roof into square. Commonly known as “racking”.

Roof panels may cause serious injury

until securely fastened.

Attach the 48 x 96" panel with the rough

side up (painted-grid lines side) with a 1/8"

measurement on the rafter (Fig A) and the

panel ush at the peak (Fig. B).

Secure panel with two 2" nails in

the corners.

BEGIN

Two Nails

48"

(122 cm)

1/8"

(3 mm)

Fig. A

Flush at peak.

Fig. B

1/8"

(3 mm)

Gable

Trim

Fig. D

Flush at peak.

Fig. C

DOOR

2" (5 cm)

PARTS REQUIRED:

x 4

7/16 x 48 x 96"

(1,1 x 122 x 244 cm)