Installation Guide

2" (5 cm)

PARTS REQUIRED:

3/8 x 48 x 72"

(1 x 122 x 183 cm)

x58

3/4"

GAUGE BLOCK

10' x 16' SIDE WALL PANELS

48"

(122 cm)

3/4"

(19 mm)

3/4"

(19 mm)

BEGIN HERE

6" (15 cm)

12" (30 cm)

For squareness maintain 3/4" and

ush under soft panel.

DOOR

Use the gauge block to mark the 3/4" measurement on the wall stud. Locate

the panel ush under the soft panel. Secure panel with two 2" nails in the

corners (Fig. A).

Ensure your wall frame is square by installing one panel and squaring frame.

Move to the opposite end. Using the long edge of the panel as a lever move the panel side-to-

side until you have a 3/4" measurement on the wall stud. Secure corner with two 2" nails.

3/4" Gauge Block

Fig. A

Fig. B

3/4"

(19 mm)

3/4"

(19 mm)

2 Nails

Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.

Place the 48 x 72" panel onto wall frame with primed side up as shown.

Note the lip and square edges.

LIP

EDGE

SQUARE

EDGE

Flush

Do not nail

in groove.

There will be an

overhang at top.

Primed Side