Installation Guide

125"
(317,5 cm)
1/4" (6 mm)
Gap
Gusset
24
RAFTERS
2" (5 cm)
FINISH
5
Nail gusset onto rafter using 2" nails, staggered, as shown.
Repeat steps 1-3 to build two more assemblies for 10' x 8' Kit, four more assemblies
for 10' x 12' Kit, or six more assemblies for 10' x 16' Kit.
Flip over rafter assembly and nail gusset to back side.
Unscrew jig and save blocks. Set aside rafters and proceed to building your back wall.
Contact at
peak.
4
3
2
BEGIN
¸
1
PARTS REQUIRED:
2 x 4 x 65-7/8" (5 x 10 x 167 cm)
6 x 24" (15 x 61 cm)
x6/x10/x14
x6/x10/x14
x72
CV
Place two rafter halves CV on  oor jig. You will assemble (4) rafters.
DOOR
NH as
temporary
supports
OO as
temporary
support
Rafter jig on wood  oorRafter jig on concrete slab and sill plates