Installation Guide

Fig. C
DOOR
151-1/2"
(385 cm)
151-1/2"
(385 cm)
16
PARTS REQUIRED:
92-5/8"
(235 cm)
10' x 8' FLOOR PANELS
(Not Included)
x55
2" (5 cm)
(2) Nails
Flush
Fig. A
Flush
at top
corner
edge.
Fig. B
(2) Nails
DOOR
Attach the 48 x 92-5/8" panel with the rough side up (painted-grid lines side)
with the 48" edge and corner ush to the oor frame (Fig A). Secure panel
with two 2" nails in the corners.
Move to the opposite end. Using the long edge of the panel as a lever move the
panel side-to-side until the top corner is ush to the oor frame (Fig. B).
Secure panel with two 2" nails in the corners.
2
BEGIN
1
3
4
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Ensure your oor frame is square by installing one panel and squaring frame.
Check the oor frame is square by measuring diagonally across the frame corners. If the measurements are the
same your oor frame is square. The measurement will be approximately 151-1/2" (385 cm) (Fig. C).
48" x 92-5/8"
(122 x 235,3 cm)
x1
Flush
6" (15 cm) edges of panel.
12" (30,5 cm) inside panel.
Grid lines UP
3/4"
(19 mm)
Approximately
120"
(305 cm)
48"
(122 cm)
Flush
FLOOR PANELS NOT INCLUDED.
SEE PAGE 8 FOR PANEL SIZES
AND QUANTITIES.