Installation Guide

ManualsBrandsHeartland ManualsWood Storage Sheds184581

DOOR

• 3" Screw angled into 4x4.

• (2) at each point frame

and 4x4 touch.

Put both  oor sections together and attach as shown using 3" nails.

You have  nished your  oor frame. Proceed to level and square frame.

10 x 12' FLOOR FRAME (Not Included)

(4) Nails per side,

stagger pattern.

FINISH

LEVEL AND SQUARE FLOOR FRAME

Before attaching  oor decking, it is important to level and square the  oor frame.

A level and square  oor frame is required to correctly construct your shed.

BEGIN

Use level and check the frame is level before applying  oor panels.

Check for frame squareness by measuring diagonally across corners. If the measurements are the

same, the frame is square. The diagonal measurement will be approximately 185" (470 cm).

When the frame is level and square secure one side of frame to the 4x4 runners using one fastener at

ends of each runner. At the opposite end of the frame, secure the frame to 4x4 runners with one fastener

at ends of each runner making sure the frame remains square (Fig. A).

Once the  oor frame is level and square fasten the frame at each point the frame contacts the 4x4

runners. Go to page 16.

See page 8 for the preferred  oor leveling method.

Fig. A

3" (7,6 cm)

x20

140-5/8"

(357,2 cm)

120"

(305 cm)

Section 2

Section 1

185"

(470 cm)

Runners are generally

12" (30,5 cm) from

ends of  oor frame

and under seams.

4x4 Runners

(not included).

Seam

12"

(30,5 cm)

36"

(91,4 cm)

40-5/16"

(102,4 cm)

Centered