Installation Guide

42
Place bolts onto OO in open position with bolt ends 3/8" (1 cm) down from frame.
Bolt is open when loop is contacting base (Fig A).
Mark and pre-drill holes for screws.
Install bolt with screws supplied and drill 5/16" (0,8 cm) hole deep enough for bolt
to slide into.
Place bolts onto OO in open position with bolt ends 1/2" (1,3 cm) up from oor. Bolt
is open when loop is contacting base (FigB).
Mark and pre-drill holes for screws.
Install bolt with screws supplied and drill 5/16" (0,8 cm) hole deep enough for bolt
to slide into.
You have nished installing
your barrel bolts.
LEFT
DOOR
5/16" (0,8 cm) Drill Bit
PARTSREQUIRED:
DOOR HARDWARE
2
3
4
BEGIN
1
x2
x8
1" (2,5 cm)
HINT: With door
closed extend bolt
and tap with hammer
to leave a mark in
wood for drilling.
Fig. A
Fig.B
OO
OO
FLOOR
FINISH
8
PRE-DRILL
(4)HOLES
PRE-DRILL
(4)HOLES
3/8" (1 cm)
1/2" (1,3 cm)
2 x 3 x 69"
2 x 3 x 69"
5/16" (0,8 cm) drill for
bolt. 1" (2,5 cm) deep.
5/16" (0,8 cm) drill for
bolt. 1" (2,5 cm) deep.
OVERDOOR
FRAME
LOCATEANDPRE-DRILLHOLES
TOAVOIDSPLITTINGWOOD
OPENPOSITION
spring is loose.
OPENPOSITION
spring is loose.
Loopcontacts
base.
Loopcontacts
base.
x4
x4
with bolt
in open
position.