Installation Guide

ROOF PANELS
Keep spacing between the center of
the rafters at the lower edge of the
panel and secure with one 2" nail into
each rafter (Fig. E).
Move to the top of the panel and keep
spacing between the center of the
rafters. Secure with one 2" nail into
each rafter (Fig. E).
Nail the roof panel using 2" nails 6"
apart on edges and 12" apart inside
panel (Fig. F).
3
Attach the lower roof panel fl ush to
the upper panels and with a 1/2"
measurement at the gable trim (Fig.G).
Nail the roof panel using 2" nails 6" apart
on edges and 12" apart inside panel.
Repeat process to attach roof
panels on the opposite side.
4
12"
(30,5 cm)
6" (15,2 cm)
Fig. F
7-7/8"
(20 cm)
96"
(243,8 cm)
1/2"
(1,3 cm)
Gable Trim
Flush
Fig. G
PARTS REQUIRED:
2" (5,1 cm)
x86
24-1/2"
(62,2 cm)
24-1/2"
(62,2 cm)
24"
(61 cm)
24"
(61 cm)
Fig. E
NOTE: Measurements from outside of gable trim.
2" Nail
x2
7/16 x 7-7/8" x 96"
(1,1 x 20 x 243,8 cm)
36