Installation Guide

ROOF PANELS

Move to the opposite end. Using the long

edge of the panel as a lever move the panel

side-to-side until the top corner is ﬂ ush

to the peak (Fig. C) and there is a 1/2"

measurement to the gable trim (Fig. D).

You may need to move your backwall to get

the 1/2" measurement. Secure panel with

two 2" nails in the corners.

You must square the roof by attaching one panel ﬁ rst. You will use the panels’ long

edge as a lever to bring your roof into square. Commonly known as “racking”.

Roof panels may cause serious injury

until securely fastened.

Attach the 48 x 96" panel with the rough

side up (painted-grid lines side) with a 1/2"

measurement on the gable trim (Fig A) and

the panel ﬂ ush at the peak (Fig. B).

Secure panel with two 2" nails in

the corners.

BEGIN

Two Nails

48"

(121,9 cm)

1/2"

(1,3 cm)

1/2"

(1,3 cm)

Flush at peak.

Fig. B

Gable

Trim

Gable

Trim

Fig. D

Flush at peak.

Fig. C

2" (5,1 cm)

PARTS REQUIRED:

7/16 x 48 x 96"

(1,1 x 121,9 x 243,8 cm)

Fig. A