Installation Guide

5/8 x 48 x 92-5/8"

(1,6 x 122 x 235,2 cm)

PARTS REQUIRED:

Ensure your ﬂ oor frame is square by installing one panel and squaring frame.

FLOOR PANELS (NOT INCLUDED)

2" (5,1 cm)

Fig. C

Flush

Fig. A

Flush at top

corner edge.

Fig. B

x53

Attach the 5/8 x 48 x 92-5/8" panel with the rough side up (painted-grid lines

side) with the 48" edge and corner ﬂ ush to the ﬂ oor frame (Fig A).

Secure panel with two 2" nails in the corners.

Move to the opposite end. Using the long edge of the panel as a lever move the

panel side-to-side until the top corner is ﬂ ush to the ﬂ oor frame (Fig. B).

Secure panel with two 2" nails in the corners.

BEGIN

Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.

Use a chalk line or use pre-painted grid lines to nail into joists under panel.

Check the ﬂ oor frame is square by measuring diagonally across the frame corners. If the measurements

are the same, your ﬂ oor frame is square. The measurement will be approximately 133-5/16" (Fig. C).

133-5/16"

(338,6 cm)

133-5/16"

(338,6 cm)

92-5/8"

(235,2 cm)

48"

(121,9 cm)

Flush

12" (30,5 cm)

inside panel.

6" (15,2 cm)

edges of panel.

DOOR

Flush

Floor Panels not included

See page 4 for panel sizes

and quantities.

(2) Nails