Installation Guide

• Install felt ﬂush to all roof edges overlapping 3". Use minimal amount of rooﬁng nails to hold in place.

OK to overlap at ridge.

3" OVERLAP

Flush

PARTS REQUIRED:

• Use acrylic latex caulk that is paintable. Caulk at all horizontal and vertical seams, between the trim and walls, and all

around the door trim.

• Use a high quality exterior acrylic latex paint. When painting your building, there are a few key areas that can be easily

overlooked that must be painted:

• Bottom edge of all siding and trim

• Inside of doors and all 4 edges

Note:

Prime all un-primed exterior wood before painting.

(Follow directions provided by manufacturer.)

PAINT & CAULK

Ø-.3Ø(-"+4#$#Ø

ROOF FELT

Ø-.3Ø(-"+4#$#Ø

DRIP EDGE

Ø-.3Ø(-"+4#$#Ø

Snip bottom side of drip edge and

bend over to other side of roof.

(Follow directions provided by manufacturer.)

• Install drip edge over roof felt on gable side and

under roof felt on eave side (Fig. A).

• Do not use nails on side of drip edge that hangs over side of building.

• Only nail top of drip edge as shown.

Edge ﬂush

to trim.

Fig. A

Drip edge

Roof felt