Installation Guide

56
22-1/2"
(57 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
22-1/2"
(57 cm)
3/8"
(9,5 mm)
3/8"
(9,5 mm)
12"
(30,5 cm)
6"
(15 cm)
PARTS REQUIRED:
x2
7/16 x 47-7/8 x 48"
(1,1 x 122 x 122 cm)
x108
2" (5 cm)
3/4" GAUGE
BLOCK
x1
7/16 x 48 x 96"
(1,1 x 122 x 244 cm)
Keep spacing between the center of the rafters
at the lower edge of the panel and secure with
one 2" nail into each rafter (Fig. E).
Move to the top of the panel and keep spacing
between the center of the rafters. Secure with
one 2" nail into each rafter (Fig. E).
Nail the roof panel using 2" nails 6" apart on
edges and 12" apart inside panel.
Attach 47-7/8 x 48" roof panel flush to
first panel, flush at peak and with the 3/8"
measurement on trim (Fig. F, G).
4
Move to the opposite side of the roof and
repeat this process installing a 48 x 96”
and 47-7/8 x 48” panel.
Note the panels edges are offset from the
first panels installed.
Make sure panels are flush at the peak
(Fig H) and there is a 3/8” measurement
at the gable trims (Fig. J).
Nail the roof panel using 2” nails 6” apart
on edges and 12” apart inside panel.
5
Gable
Trim
NOTE: Measurements from inside of panels
Fig. F
Fig. H
Fig. J
Fig. G
Fig. E
2" Nails
Flush
at peak
Flush
at peak
Flush
96"
48"
ROOF PANELS