Installation Guide

55
ROOF PANELS
48"
(122 cm)
PARTS REQUIRED:
x4
2" (5 cm)
x1
2
3
BEGIN
¸
1
3/4" GAUGE
BLOCK
7/16 x 48 x 96"
(1,1 x 122 x 244 cm)
Move to the opposite end. Using the long
edge of the panel as a lever move the
panel side-to-side until the top corner is
flush to the peak (Fig. C) and there is 3/8"
measurement to the gable trim (Fig. D).
You may need to move your sidewall to get
the 3/8" measurement. Secure panel with
two 2" nails in the corners.
You must square the roof by attaching one panel fist. You will use the panels’ long
edge as a lever to bring your roof into square. Commonly known as “racking”.
Roof panels may cause serious injury until securely fastened.
Attach the 48 x 96" panel with the rough
side up (painted-grid lines side) with a 3/4"
measurement on the rafter (Fig A) and the
panel flush at the peak (Fig. B).
Secure panel with two 2" nails in
the corners.
3/8"
(9,5 mm)
Gable
Trim
Fig. D
Fig. C
Two
Nails
3/4"
(1,9 cm)
Fig. A
Gauge
Block
Flush
at peak
Flush
at peak
Fig. B