Installation Guide

44
22-1/2"
(57 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
24"
(61 cm)
22-1/2"
(57 cm)
Dimensions are to center of rafters
Dimensions are from inside of panel
Flush
DOOR
PARTS REQUIRED:
3" (7,6 cm)
x20
FINISH
7
Mark top of wall frames to measurement shown.
Hold rafter end fl ush to back wall and overhang. Secure from under overhang
using two 2" (5 cm) screw. (Fig. A)
Locate Rafter centered on marks.
Secure opposite end through panel into rafter end using one 2" (5 cm)
screw (Fig. B)
Screw rafters at each end using two 3" (7,6 cm) screws as shown. (Fig. B, C)
Repeat steps to attach 5 rafters.
At each end
(2) 3" (7,6 cm) screws
angle into 2 x 3"
2"
(5 cm) Screw
Two 2"
(5 cm)
Screws
Fig. A
Fig. C Fig. B
You have attached your rafters. Proceed to attaching your soffi t trim.
3
2
4
5
6
BEGIN
¸
1
ROOF
x15
2" (5 cm)