Installation Guide

34
CENTER
PARTS REQUIRED:
x12
x2
BACK WALL INSTALLATION
x39
3" (7,6 cm)
3" (7,6 cm)
2" (5 cm)
FINISH
4
Nail down the bottom plate using two 3"
nails between the wall studs.
Screw through the backwall trim into
the top and bottom plates using one 3"
screw (Fig. D, E).
Stand Back Wall Assembly on Floor. 1-1/2" (3,8 cm) Panel overhang is at top.
It is important to secure the Back Wall in the following order.
Nail the lower back wall corner to the side
wall trim with one 2" (5 cm) nail (Fig. A).
Center back wall on fl oor, side-to-side.
Be sure the measurement between the
panel edge and the trim is the same
along the entire length. Then secure with
one 2" nail in the upper corner (Fig. B).
Nail along the panel edge into the trim
using 2" nails spaced 6" apart.
Nail along bottom of panel using 2" nails
6" apart. Angle nail to hit fl oor frame
(Fig. C).
You have fi nished standing your Back Wall. Proceed to stand the Right Wall.
1
2
3
BEGIN
¸
2" (5 cm)
Nail
1-1/2"
(3,8 cm)
2" (5 cm)
Nail
3" (7,6 cm)
Screw
6"
(15 cm)
6"
(15 cm)
3" (7,6 cm)
nails
Trim
Panel
Fig. A
Trim
Fig. C
Fig. B
Fig. D
Fig. E
Same
Measurement
3" (7,6 cm)
Screw
Trim