Installation Guide

31
3/4"
(1,9 cm)
6" (15 cm)
Flush
48"
(122 cm)
3/4"
(1,9 cm)
12"
(30 cm)
PARTS REQUIRED:
x1
x34
2" (5 cm)
FRONT WALL
For squareness, maintain flush
and 3/4" measurement along
panel edges.
BEGIN HERE
3/4" GAUGE
BLOCK
3/4" GAUGE
BLOCK
There will be
an overhang
at top and
bottom
Flush panel
under
overhang
Fig. A.
2
3
1
Do not nail
in groove.
Primed
side up
Place the panel onto wall frame flush under overhang with primed side
up as shown (Fig. A).
Use the gauge block to mark the 3/4" measurement on the wall stud.
Secure panel with two 2" nails in the corners (Fig. B).
Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Ensure your wall frame is square by installing one panel and
squaring frame.
Move to the opposite end. Using the long edge of the panel as a lever
move the panel side-to-side until you have a 3/4" measurement on the
wall stud (Fig. C). Secure corner with two 2" nails.
Fig. C
Fig. B
3/4"
(1,9 cm)
3/4"
(1,9 cm)
2 Nails
Flush
2 Nails