Installation Guide

27
1-1/2"
(3,8 cm)
3/4"
(19 mm)
48"
(122 cm)
12"
(30 cm)
6"
(15 cm)
Flush
1-1/2"
(3,8 cm)
48"
(122 cm)
12"
(30 cm)
6"
(15 cm)
Flush
PARTS REQUIRED:
x2
x192
2" (5 cm)
3/8 x 48 x 72" (1 x 122 x 183 cm)
2 x 3 x 13" (5 x 7,6 x 33 cm) as spacer
x1
RK
HINT:
Use RK as
1-1/2" gauge
HINT:
Use RK as
1-1/2" gauge
3/4" GAUGE
BLOCK
There will be a
side overhang
at top and bottom
BACK WALL
LIP
EDGE
SQUARE
EDGE
LIP
EDGE
Place center 48" panel on frame as
shown with primed side facing up.
NOTE THE SQUARE AND LIP EDGES.
Nail using 2" nails 6" apart on edges
and 12" apart inside panel.
6
Do not nail
in groove.
Place end 48" panel on frame as shown
with primed side facing up.
NOTE THE SQUARE AND LIP EDGES.
Nail using 2" nails 6" apart on edges
and 12" apart inside panel.
7
You have fi nished building your back wall.
FINISH
8
Primed
side up
Primed
side up
For squareness maintain
fl ush and 1-1/2" measurement
along panel edges.
For squareness maintain
fl ush and 1-1/2" measurement
along panel edges.