Installation Guide

26
48"
(122 cm)
3/4"
(1,9 cm)
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
12"
(30) cm
6"
(15 cm)
For squareness, maintain 3/4" and
1-1/2" measurement along panel edges.
4
5
3
PARTS REQUIRED:
x1
x34
2" (5 cm)
3/8 x 48 x 72"
(1 x 122 x 183 cm)
BEGIN HERE
HINT: Use RK
as 1-1/2" gauge
2 x 3 x 13" (5 x 7,6 x 33 cm) as spacer
x1
RK
3/4" GAUGE
BLOCK
There will be an overhang
at top and bottom
BACK WALL
Do not nail
in groove.
Primed side up
Fig. B
Fig. A
1-1/2"
(3,8 cm)
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
3/4"
(1,9 cm)
2 Nails
2 Nails
SQUARE
EDGE
3/4"
GAUGE
BLOCK
Place the 48 x 72" panel onto wall frame with primed side up as shown.
Note the lip and square edges.
Use the gauge block to mark the 3/4" measurement on the wall stud.
Use RK as a 1-1/2" gauge block at top. Secure panel with two 2" nails in
the corners (Fig. A).
Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Ensure your wall frame is square by installing one panel and
squaring frame.
Move to the opposite end. Using the long edge of the panel as a lever
move the panel side-to-side until you have a 3/4" measurement on the
wall stud. Secure corner with two 2" nails (Fig. B).