12'x8' Stratford Instructions

3
OPTIONAL MATERIALS
DRIP EDGE ..................... 40 Feet #15 ROOFING FELT
To cover 114 Sq. Ft. of roof area.
1" GALVANIZED ROOFING NAILS.........1/4 Lb
For roong felt.
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER’S INSTRUCTIONS
FOR INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
COMPLETING YOUR SHED
You will need these additional materials:
3-TAB SHINGLES ............................. 5 Bundles
PAINT FOR SIDING .......................... 2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK ................................................. 3 Tubes
Use acrylic latex exterior caulk that is paintable.
1" GALVANIZED ROOFING NAILS.... 2 Lbs
For shingles.
PAINT FOR TRIM ............................ 1 Quart
Use 100% acrylic latex exterior paint.
WOOD GLUE ....................... Exterior Rated
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! The included oor has been designed for general use.
Depending on your specic use you may want to construct a heavy
duty oor frame by adding additional oor joists (shown below as
shaded). Below is a list of additional materials (not included):
x6
x20
2 x 4 x 8' (5 x 10 x 244 cm) Treated Lumber
Cut to (3) 2 x 4 x 93" (5 x 10 x 236,2 cm)
ea. 3" (7,6 cm) Hot Dipped Galvanized Nails
Optional 12" (30,5 cm) spacing.
Standard 24" (61 cm) spacing.
FOUNDATION OR FLOOR MATERIALS
ADDITIONAL MATERIALS
• This shed kit includes a complete wood oor frame system. It does not include oor materials.
• This shed does not include ANY leveling materials.
• See the FLOOR LEVELING section on page 8 for recommended methods and suggested materials to properly level your
oor, as this will vary depending on your specic site.
Floor Panels are
3/4" (1,9 cm) thick
3/4 x 48 x 96"
(1,9 x 121,9 x 243,8 cm)
3/4 x 45 x96"
(1,9 x 114 x 243,8 cm)
x2
x1
FLOOR PANELS (NOT INCLUDED)