Installation Guide
39
RAFTER JIG
x2
3" (7,6 cm)
x3
x1
3/8 x 5-3/8 x 5-1/2" (1 x 13,6 x 14 cm)
2 x 3 x 13" (5 x 7,6 x 33 cm)
RK
101-3/8"
(257,5 cm)
Important
measurement
DOOR
FINISH
4
Make a rafter jig to make sure all rafters are assembled the same.
Measure from corner of backwall and RK (already installed) as shown.
Secure RK on the at square to back wall at measurement using
two 3" (7,6 cm) screws.
Attach a second RK on edge and 3/8" thick angle trim piece as shown (Fig. A).
You have nished building your rafter jig.
Required because rafter
is uneven at bottom
2
3
PARTS REQUIRED:
RK
End Cap
3/8 x 5-3/8 x 5-1/2"
(1 x 13,6 x 14 cm)
3" (7,6 cm) screw
must drive in all the way
2-1/2"
(6,4 cm)
RK
Fig. A
RK