Installation Guide

35
RIGHT WALL INSTALLATION
6"
(15 cm)
PARTS REQUIRED:
x6
x4
x31
3" (7,6 cm)
3" (7,6 cm)
2" (5 cm)
FINISH
4
Nail down RK using three 3" nails on
each as shown and secure center wall
frame using two 3" screws (Fig. D).
Screw through the right wall trim into the
top and bottom plates using
3" screws (Fig. E, F).
Stand right wall assembly on  oor.
It is important to secure the right wall
in the following order.
Nail the lower back wall corner to the right wall trim.
Secure with one 2" (5 cm) nail (Fig. A).
Center right wall on  oor, side-to-side.
Be sure the measurement between the panel
edge and the trim is the same along the
entire length. Then secure with one 2" nail in
the upper corner (Fig. B).
Nail along the panel edge into the trim using
2" nails spaced 6" apart.
Nail along bottom of panel using 2" nails 6"
apart. Angle nail to hit  oor frame
(Fig. C).
You have  nished standing your right wall. Proceed to stand the front Wall.
1
2
3
BEGIN
2" (5 cm)
Nail
Fig. A
Trim
CENTER
2" (5 cm)
Nail
3" (7,6 cm)
Screw
Trim
Fig. B
Fig. E
Fig. F
Same
Measurement
6"
(15 cm)
3" (7,6 cm)
nails
Back
Panel
Fig. C
Fig. D
RK
(2)
3" (7,6 cm)
Screws
3" (7,6 cm)
Screw
Trim