Installation Guide

12
Move to the opposite side. Using the long edge of the panel as a lever, move the
panel side-to-side until the top corner is ush to the oor frame (Fig. B).
Secure panel with two 2" nails in the corners.
2
BEGIN
1
3
4
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Ensure your oor frame is square by installing one panel
and squaring frame.
Check the oor frame is square by measuring diagonally across the frame corners. If the measurements are the
same your oor frame is square. The measurement will be approximately 170-9/16" (433,3 cm) (Fig. C).
PARTS REQUIRED:
x1
5/8 x 45 x 96"
(1,6 x 114 x 243,8 cm)
x62
2" (5,1 cm)
FLOOR PANELS (NOT INCLUDED)
Attach the 5/8 x 45 x 96" panel with the rough side up (painted-grid lines side) with the
45" edge and corner ush to the oor frame (Fig A). Secure panel with two 2" nails in the
corners.
Floor panels not included. See
page 3 for panel sizes
and quantities.
48"
(122 cm)
141"
(358 cm)
96"
(243,8 cm)
Flush
(2) Nails
170-9/16"
(433,3 cm)
170-9/16"
(433,3 cm)
Fig. A
Fig. B
Fig. C
3/4"
(1,9 cm)
13"
(33 cm)
3/4"
(1,9 cm)
6"
(15 cm)
12" (30 cm)
3/4"
(1,9 cm)
Flush
(2) Nails
45"
(114 cm)
141"
(358 cm)
6"
(15 cm)
Grid lines up
12"
(30 cm)
Flush
Flush
Flush
(2) Nails
(2) Nails
3/4"
(1,9 cm)
Fig. A
Fig. B
96”
(243,8 cm)
DOOR