User Guide

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07
26
Log Assembly: LOGS-SOHOCE
E. Positioning the Logs
CAUTION: Logs are fragile. Carefully remove the logs
from the packaging.
2
2
1
1
Step 1. Place Log #1 (SRV2111-700) against rear right
tab with its slot over center locating tab.
Step 2 Place Log #2 (SRV2111-701) onto base pan such
that Log #2 fi ts in groove of Log #1. Push it back against
the left hand side locating tab. Ensure burner ports are not
covered by logs.
Step 3. Place Log #3 (SRV2111-702) so the top rests on
Log #1 against Log #2. The base slot on Log #3 will fi t
over the locating tab on the front right hand side.
LOCATING TABS
Figure 12.2
Figure 12.6
3
3
1
1
2
2
1
1
2
2
Figure 12.4
Figure 12.5
Figure 12.3
1
1
3
3