Stove User Manual

R
Page 20
November 22, 2011
Isle Royale Wood Stove
250-5763E
7
Appliance Set-Up
Locknut
Door Cross Section
Latch Cam
Spacing Washers
Square Key
Handle
Teflon Washer
DO NOT
REMOVE
Included in Kit: 1 locknut, 1 porcelain handle, 1 screw
adapter, 1 gold or nickle handle, 1 square key, 4 spacing
washers, 1 cam latch
Tools Needed: 9/16 box end wrench, fl at head screwdriver.
1. Install tefl on washer on door handle shaft.
2. Slide door handle through door.
3. Install spacing washers(s) as showin in Figure 20.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft.
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
INSTALL PORCELAIN HANDLE:
1. Insert handle adapter with threads going into the porce-
lain handle. Figure 20.2.
2. Thread in completely, using a fl at head screwdriver.
Figure 20.1
Porcelain
Handle
Thread
End
Figure 20.2
A. Door Handle Assembly
B. Adjusting The Blower Speed Control
If Necessary
NOTE: When the speed control is turned clockwise, it will
click on to high speed. Turn the speed control
clockwise to decrease the speed. At full
clockwise, the blower should blow gently, but
should not stop.
1. With the stove plugged in, turn the speed control knob
to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole on
the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.