Stove User Manual

Page 13
Isle Royale Wood Stove
R
250-5763E
November 22, 2011
OUTSIDE AIR
TERMINATION CAP
(contains rodent screen)
FLEX FLANGE
1. Remove all materials from packing box.
2. Mount the fl ex fl ange (with pipe fi tting extending out),
over the intake air opening at the rear of stove using the
four mounting screws supplied with kit.
3. Cut a 4 inch (102mm) minimum hole in the fl oor or wall
to accommodate outside air piping. Use 4 inch (102mm)
metal fl ex or rigid piping to directly connect outside air to
the unit or into vented crawl space. (Do not put fl ex into
a non-vented crawl space).
4. If using fl ex tubing attach cable ties to secure tubing at
both ends. Use the supplied termination cap with a rodent
screen. Seal between the fl oor or wall and the pipe with
silicone to prevent moisture penetration.
Items Needed for Installation: 4 inch (102mm) diameter
fl ex pipe in the length as required for your installation; Phil-
lips screwdriver; Silicone sealant; Drills and saws necessary
for cutting holes through the wall or fl ooring in your home.
Included in Kit: 1 fl ex fl ange; 2 cable ties; oustide air termi-
nation cap; mounting screws (Discard the remaining parts).
C. Outside Air Kit Installation
NOTE: If you plan to install the optional blower and the
outside air kit, complete installation of the outside
air kit fi rst.
1. Remove 3 Phillips head screws from rear of unit.
2. Using the Phillips head screws, attach blower to lower
rear of stove, as shown.
3. Plug blower cord into a grounded outlet. Do not remove
ground prong from plug. Route power cord to avoid
heat from the stove, or other damage. Do not route
cord under or in front of appliance.
4. Adjust the blower speed control to the desired speed.
D. Installation Of Optional Blower
The blower is shipped fully assembled and ready
for installation.
*The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
Rear Shield
Blower Mounting
Flange
Blower Speed Control
Blower
Mounting
Flange
Rear
Shield
Figure 13.1
Figure 13.2