- Hearth & Home Technologies 3100 Wood Stove Series Advanced Combustion Control(ACC) Owner's Manual Installation and Operation

Page 22
7033-277F
September 1, 2008
R



Grate
ARS
Channel
Replace both bricks
back into firebox

Cover
Plate
Ash Removel
Drawer
Adapters
Oak
Pedestal
Trim


1. Remove screws on adapter and slide pedestal over
adapter on bottom of stove. 
2. Line up holes in sides of pedestal with holes in adapter.
. Securely tighten pedestal into place.
4. Carefully stand stove up and place in desired location.
5. Slip wooden decorative strips onto pedestal edges.

1. Re-install the ARS channel that was removed in Step  on
page one and secure with 2 bolts previously removed.
S et the grate into the ARS channel Replace the 2
front cut bricks. 
2. Install the ash drawer.
. Check to make sure bafe boards and ceramic blanket are
in their proper locations. .
NOTE: If installing a oor installation of an outside air kit on a
Step Top model with a pedestal assembly you must attach
the enclosed cover plate to the back of the stove. Other
wise you may discard this piece.