Model no: IC360 INDUCTION COOKER BATCH NUMBER: PR3558 PLEASE READ AND RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
• • • • • • • • • • • • • • • • • • • • • • • • SAFETY INSTRUCTIONS This appliance is for household use only. It is not suitable for commercial use. It must only be used for its intended purpose. This appliance is for indoor use only, it is not suitable for outdoor use.
• Do not place anything between the top plate of the appliance and the base of the cooking pot or pan. This can interfere with the magnetic field of the cooker and cause a hazard. • Do not subject the appliance to impact as the top plate is very fragile. Do not use the appliance if the top plate is cracked. After use and before cleaning, turn off the appliance, unplug the appliance and let it cool down. Do not use abrasive cleaners or scourers as they will damage the appliance.
SUITABLE POTS/PANS FOR USE WITH THE INDUCTION COOKER Use iron, cast iron, stainless steel (with high steel content) pots or pans with the induction cooker. Ensure the diameter is between 12cm-26cm. Ensure that the pots or pans have a flat base.
The induction cooker has an automatic pot checking feature which will not allow the appliance to operate if the pot or pan being used is not compatible. When the power button is pressed, the appliance will not operate. You will need to change to a different pot or pan which is suitable for use with the induction cooker. PANEL OPERATING INSTRUCTION 1. Put the appliance on top of a suitable bench top. 2. Connect the power plug into the power point. 3. There will be a beep sound and the appliance will be on.
10. PRE-SET TIMER: When the unit is in SOUP, MILK or WATER modes, the pre-set timer function can be set. The unit will begin operation when count down time has finished. Press the PRE-SET TIMER button once, “: 00” will flash on the display. Press the arrow buttons to set the minutes, then press PRE-SET TIMER button again, “00:” will flash on the display, then press the arrow buttons to set the hours. Once you have made your countdown time selection, do not press any button for 8 seconds.
ERROR MESSAGES SCREEN Display E0 E1 FAULT Detector Main PCB at fault Utensil not placed correctly, pot size or type is not correct Supply voltage too low Supply voltage too high Heat sensor open circuit or short circuit IC error or PCB error Over current protection IGBT open circuit or short circuit Top plate over heated IGBT over heated E2 E3 E4 E5 E6 E7 E8 E9 TROUBLE SHOOTING Condition No sound and no display after pressing the on/off button. Possible cause 1.
