Instructions / Assembly

RECALLING MEASUREMENTS IN MEMORY

You can recall up to 120 total measurements in memory (60 per

bank).

1. First, select the correct User bank, by pressing and holding

the POWER button for 5 seconds, then release. The user

symbol will begin to blink, Fig 1. Then press the MEMORY

button to switch between User 1 & 2. Once the desired user

is selected, press and hold the POWER button for 3 seconds

until the unit powers OFF.

2. Press and release the MEMORY button. It will display the

average of the last three readings, Fig. 2.

3. Press the MEMORY button again to scroll through the saved

measurements.

NOTE: When the number of readings exceeds 60 per bank, the

oldest data will be replaced with the new record.

To erase all stored measurements:

1. Press and release the MEMORY button to enter into the

memory bank mode. Be sure the correct memory bank is

selected.

2. Press and hold down the POWER button until three horizontal

lines flash. This indicates that all measurements have been

erased, Fig. 3.

mmHg

Fig. 2

Fig. 3

Fig. 1